You can connect a network input to a block input. You can configure up to 64 network inputs.

Digital network inputs can read values from the following types:

• VM

• Slave

• Diagnostic

When reading values from VM, the VB address range is 0 to 850.

If you read a value from a slave Basic module, you must enter the slave IP address. The block type is the input or output of the slave. Network inputs can read values from I1 to I24 or Q1 to Q16 of a slave Base Module.

If you read a value from the diagnostic information, you need to select a diagnostic type first, as shown in the following figure. The four diagnostic types correspond to four bits in the VM area. Each of the four bits is set to 1 or 0, which respectively indicates that an error of this type exists or not.

Overview

Network inputs are inactive in the UDF Editor.